Brusa BDC546 - Pin 9 CNL, Pin 10 CNH

39
Technical data
and start-up
BDC546
7.1.4 pin 9 CNL, pin 10 CNH
Internal wiring
 CAN 2.0 B (baud rate can be set, e.g. 250 k, 500 k, 1 Mbit)
 Termination of the CAN interface is not intended in the DC/DC converter (CAN terminating resistor)
 Via the CAN interface, messages can be transmitted in accordance with the CAN matrix
provided by BRUSA
as dbc file.
 The following parameters of the CAN messages can be modified via the PARAM software:
 Identifier
 Baud rate
 Bit timing