Brusa BDC546 - Pin 13 PRO for Programming

41
Technical data
and start-up
BDC546
7.1.6 Pin 13 PRO
NOTICE
Programming an incorrect firmware may damage the device!
Therefore, programming may only be carried out after consultation with BRUSA Elektronik AG!
INFORMATION
This pin is only activated for programming of a new firmware (pin 13 PRO = high). For this purpose,
pin 16 EN does not need to be high.
Internal wiring
 It is highly recommended to disconnect the device from the HV supply prior to programming!
 The device has to be supplied via the AUX wiring system and pin 13 PRO = high (7-16
V) when it is set to
programming mode. Afterwards, programming can be carried out via the serial interface.