PS S3.2 3550
001 OE35
Version no T-code
F-code Section C-code
Load Wheels
102
Service Manual 1997-09-15
7. Install new load wheel (11) and bearing (10) as
needed.
7. Install load wheel assembly in support arm. Slide
axle (7) in support arm from outside and install nut
(6).
8. Tighten nut (6) only until all end play is removed
from load wheel assembly. Then turn nut (6) to
closest slot that lines up with roll pin (5) hole and
install roll pin (5) to lock nut (6) in place.
To Next Page
Loading...
