PS S5.5 5710
000
Version no T-code
F-code Section C-code
EV100 Handset Operation
228
Service Manual 1997-09-15
2. Purpose
The purpose of the Handset is to allow
authorized personal
to perform the following functions:
Monitor existing system fault codes for both traction
SCR systems.
Monitor intermittent random status code.
Monitor battery state of change on LXT systems.
Monitor hourmeter reading on traction SCR systems.
Monitor or adjust the following control functions:
- Creep speed
- Controlled Acceleration and 1A time
- Current Limit
- Steer pump time delay
- Plugging distance (Current)
- Pedal position plug range or disable
- A drop out current or disable
- Speed limit points (SL1,SL2, and SL3)
- Internal resistance compensation for battery state of
charge indication
- Battery voltage (36/48 volts is auto ranging)
Selection of card operation type:
- Standard traction card selection:
- Standard traction with Field Weakening
- Standard traction with speed limits
- Standard traction with Regan/Field Weakening
- High or Low current limit for all of the above.
To Next Page
Loading...
