PS S0.1 0340
001 OE35
Version no T-code
F-code Section C-code
Inspection Covers
60
Service Manual 1997-10-23
1. Removal Of Plastic Dash Panel
Before starting disassembly of any parts, thoroughly clean
out side of assembly with safety solvent or other non-
corrosive cleaning fluid. Air dry all parts.
1. Park the truck on a level surface and make sure
load wheels are blocked to prevent accidental
movement.
2. Fully lower the mast.
3. Disconnect and remove battery from unit to
prevent accidental operation.
4. Remove back shield (11) from rear of operator
platform.
5. Remove windshield bracket and windshield.
6. Remove steering wheel. Use puller (split bearing
type).
7. Remove retainer ring from steering shaft.
8. Loosen steering chain stop.
9. Remove chain from idler sprocket and steer
indicator sprocket.
10.Tap steering shaft 2 in. toward front of truck.
11.Loosen steer indicator idler sprocket bracket.
Remove beaded chain.
12.Remove key switch by rotating lock on back of
switch clockwise.
13.Disconnect emergency disconnect and start button
wires. Remove emergency disconnect and start
button.
14.Disconnect gauge wires. Remove gauges.
15.Remove three cap screws holding master switch
bracket.
Be extremely careful when working with
solvent. Even a small explosion or fire
could cause injury or death.
WARNING
To Next Page
Loading...
