PS S5.5 5710
000
Version no T-code
F-code Section C-code
EV100 Handset Operation
230
Service Manual 1997-09-15
4. Function Set-Up Procedures
With the Handset connected, hold down the CONT key and
turn on the key switch. This will place you in the set up mode,
ready or monitor or adjust control function settings.
At this point another function can be monitored/changed by
pushing another function number, or the truck can be placed
in the run mode by holding the ESC key down for one second
or longer. The display will return to either the diagnostics
mode or the BDI display or a blank display (if BDI is not used
and there are no fault codes). The truck can now be operated
with the handset connected or the handset can be
Set Up Mode
Action Display shows Remarks
Hold down CONT, turn on key 8888 Segment check displayed
Push function number U 005 Selected function number is displayed
After one second time delay 085 Stored value for the function is displayed
Push CONT 088 Displayed valve will blink
Charge value with adjustment knob 0125 Value changes while blinking
Push STORE 0125 New valve stored and blinking stops
Push ESC 8888 Segment check displayed
Before making any adjustments to the
control you must consult the operating and
maintenance instructions supplied by the
vehicle manufacturer. Failure to follow
proper set up instructions could result in
mis-operation or damage to the control
system.
WARNING
NOTE!
The term push, means to depress key for
approximately one second.
To Next Page
Loading...
