PS S3.2 3560
001 OE35
Version no T-code
F-code Section C-code
Stabilizing Caster Spring Loaded
104
Service Manual 1997-07-15
1. Removal
1. Park the truck on a level surface and make sure
parking brake is applied.
2. Release pressure in hydraulic system by pressing
the lowering button on steering control handle.
3. Disconnect and remove battery from unit to
prevent accidental operation.
4. Raise and block drive end of truck so casters
wheels are 2 in. to 3 in. off the floor.
5. Open access door fully and disconnect negative
wire from hydraulic pump solenoid to prevent pump
from operating.
6. Remove four cap screws and nuts securing caster
assembly to frame.
7. Remove caster assembly from truck.
8. Before disassembly, thoroughly clean exterior of
the caster assembly in a cleaning solvent to
remove all contamination.
NOTE! CLEANLINESS!
Perform procedures in a clean
environment. Make sure all parts are cleaned
before disassembly and kept clean during
assembly.
Be extremely careful when working with
solvent. Even a small explosion or fire could
cause injury or death.
WARNING
Compressed air used for cleaning
MUST
be
reduced to less than 30 p.s.i., and then only
with effective chip-guarding and personal
protective equipment.
WARNING
Be extremely careful when working with
solvent. Even a small explosion or fire could
cause injury or death.
WARNING
To Next Page
Loading...
