Lift Pump Assembly
PS M6.1 6140
F-code Section C-code
Version no T-code
001 OE35
© BT Products
251
Service Manual 1997-12-15
2. Disassembly
1. Before disassembly, clean exterior of the hydraulic
pump and motor assembly in a cleaning solvent to
remove all contamination.
2. Set unit in vertical position with pump end up.
3. Scribe a line on both pump and motor to aid when
reassembling.
4. Remove two screws and washers securing pump
to motor.
5. Tap pump lightly to loosen. Lift pump off.
6. Clean exterior of pump in a cleaning solvent to
remove all contamination.
7. Scribe a line on both body and base of pump to aid
when reassembling.
8. Secure pump in vise (with soft jews use light
clamping pressure) with shaft end down, remove
screws (12) and washers (11).
NOTE! CLEANLINESS!
Perform procedures in a clean
environment. Make sure all parts are cleaned
before disassembly and kept clean during
assembly.
Be extremely careful when working with
solvent. Even a small explosion or fire could
cause injury or death.
WARNING
Compressed air used for cleaning
MUST
be
reduced to less than 30 psi. and then only
with effective chip-guarding and personal
protective equipment.
WARNING
To Next Page
Loading...
