PS S3.2 3560
001 OE35
Version no T-code
F-code Section C-code
Stabilizing Caster Spring Loaded
106
Service Manual 1997-07-15
2. Inspection
1. Thoroughly clean all parts and remove all nicks
and burrs with emery cloth.
2. Inspect all bolts (4) and replace if needed.
NOTE! CLEANLINESS!
Perform procedures in a clean
environment. Make sure all parts are cleaned
before disassembly and kept clean during
assembly.
Be extremely careful when working with
solvent. Even a small explosion or fire could
cause injury or death.
WARNING
Compressed air used for cleaning
MUST
be
reduced to less than 30 p.s.i., and then only
with effective chip-guarding and personal
protective equipment.
WARNING
To Next Page
Loading...
