Planned Maintenance Procedures
PS P2.0
F-code Section C-code
Version no T-code
000 OE35
© BT Products
47
Service Manual 1997-10-21
2. Services to be performed monthly
or every 250 operating hours
The monthly planned maintenance service should be
performed by a qualified technician.
2.1. Inspection
All of the services and inspections listed above for the daily
inspection should be performed at this time. The inspection
procedure should be more thorough, and minor deficiencies
should be corrected.
2.2. Transmission
Inspect for oil leakage.
2.3. Brakes
The brakes should stop a fully loaded truck at full speed in
approximately one truck length.
2.4. Battery
Contact your battery dealer for specific instructions on care
and maintenance of the battery.
An average battery will have a specific gravity of 1.170 at the
80% discharged level. However, there are many different
batteries on the market. Only the battery manufacturer can
accurately determine the fully charged and 80% charged
levels. Contact the battery manufacturer for this information.
To Next Page
Loading...
