Stabilizing Caster Spring Loaded
PS S3.2 3560
F-code Section C-code
Version no T-code
001 OE35
© BT Products
107
Service Manual 1997-07-15
3. Disassembly
1. Before disassembly, thoroughly clean exterior of
the caster assembly in a cleaning solvent to
remove all contamination.
1. Remove axle (5) from yoke (4) and remove the
wheel assembly.
2. Remove cap (6) from the yoke (4).
3. Remove roll pin (9) and nut (8) from the base plate
spindle.
4. Clean and inspect all bearing and replace as
needed.
5. Assemble caster in reverse order.
3.1. Installation
1. Install caster assembly under truck, and secure
with cap screws and nuts.
2. Lift truck and remove all blocking.
3. Reconnect the negative wire to pump solenoid.
4. Connect battery to truck.
5. Close access door.
NOTE! CLEANLINESS!
Perform procedures in a clean
environment. Make sure all parts are cleaned
before disassembly and kept clean during
assembly.
Be extremely careful when working with
solvent. Even a small explosion or fire could
cause injury or death.
WARNING
Compressed air used for cleaning
MUST
be
reduced to less than 30 p.s.i., and then only
with effective chip-guarding and personal
protective equipment.
WARNING
To Next Page
Loading...
