Load Wheels
PS S3.2 3550
F-code Section C-code
Version no T-code
001 OE35
© BT Products
101
Service Manual 1997-09-15
Load Wheels
1. Park truck on level surface, and apply the brake.
2. Hoist machine so load wheels are approximately two
inches off of the floor, and securely block.
3. Drive roll pin (5) further in support arm to allow nut
(6) to be removed.
4. Remove nut (6), axle (7), and load wheel assembly
from support arm.
5. Drive roll pin (5) from support arm.
6. Inspect bearings (10).
POS.
NO
DESCRIPTION
POS.
NO
DESCRIPTION
5Pin, roll 9Seal, oil
6 Nut 10 Bearing
7 Axle 11 Wheel, load
8 Fitting, grease
To Next Page
Loading...
