Transmission Disassembly / Assembly
PS S2.0 2550
F-code Section C-code
Version no T-code
000 OE35
© BT Products
97
Service Manual 1997-10-21
opposing locations.
Subtract the smallest number from the largest
number.
The specification for total indicated runout (TIR)
is 0.055 in.
C. If drive motor shaft and gear are not concentric,
first remove the drive motor and check for any
burrs, pieces of old gasket material, etcs., that
might cause these parts to be misaligned. If
okay, install drive motor taking special care
tightening drive motor mounting bolts.
56.Install the bearing cover over the bearing with
shims and Loctite 515.
The bearing cover must be shimmed so that it is
0.010 in. above the outer bearing race. Put shims
around bearing so they are 0.010 in. higher than
the bearing.
57.Fill transmission with about one quart of
ATF
Dextron II
.
58.Install the steering guide ring with six bolts and
lockwashers. Torque bolts to 50 ft-lb.
59.Install the drive wheel assembly to the hub with five
bolts. Torque to 100 ft-lb.
5. Installation
1. Install new pivot bearing on pivot tube with washer
under bearing.
2. Install new bearing cup in pivot tube mounting
bracket.
3. Put mounting bracket over pivot tube and install
retaining ring around top of pivot tube.
4. Attach hoist to transmission with a chain through
the pivot tube.
5. Raise and block the front of the truck about 12 in.
off the ground.
To Next Page
Loading...
