BT OE35 - When Changing Brushes

PS S1.1 1700
001 OE35
Version no T-code
F-code Section C-code
Drive Motor 24 Volt
76
Service Manual 1997-10-21
Press against the inner race when installing onto a shaft.
2. End heads having slip-fit bearings are normally
retained by a snap ring. Always install new snap
ring(s).
2.7.3. After Assembly
 The motor should be connected as specified in
Troubleshooting, and tested to the specifications.
 When testing motors, the voltmeter connections must
be made at the motor terminals.
3. When changing brushes
When changing brushes, the commutator must be serviced
as follows:
 Resurface the commutator by taking only light cuts
each time, 0.005 in. (0.12mm).
 If reslotting/undercutting is necessary, the final
operation is to lightly sand the commutator with a fine
sandpaper to remove any burrs left from the
undercutting operation.
Return