Drive Motor 24 Volt
PS S1.1 1700
F-code Section C-code
Version no T-code
001 OE35
© BT Products
75
Service Manual 1997-10-21
2.7. Assembly
2.7.1. Field Coil Installation
Good solder connections are important due to the vibration
characteristics encountered by these motors which can cause
cold or poorly soldered connections to break.
Prior to installing the field coils,
the connections
which require soldering should be buffed or wire
brushed clean to remove any oxidation. The
connections should then be tinned with a soldering
iron.
After field coil installation,
connect the solder joint
making sure the solder is flowing properly to avoid a
cold soldered joint.
Pole Shoe Screw Removal & Installation
(Field Coil Removal & Installation)
Continue assembly in the reverse of disassembly, paying
particular attention to the following points.
2.7.2. Bearing Installation
1. Whenever ball bearings are pressed into an end head
or onto a shaft, always press against the race that is
absorbing the pressure.
Press on the outer race when installing into end heads.
NOTE:
We do not recommend using a soldering
gun or torch. Soldering gun cannot
provide the heat concentration required
and soldering torches can damage the
insulation.
To Next Page
Loading...
