Torque Generator
PS S4.0 4130
F-code Section C-code
Version no T-code
001 OE35
© BT Products
115
Service Manual 1997-10-27
20.With cross pin removed, push spool forward to
disengage the control spool and centering springs
from the sleeve.
21.Remove centering springs from the control spool (and
if applicable, four spring spacers). Retaining ring on
spool need not be removed if no damage is apparent.
NOTE!
To prevent possible loss of the (six)
centering springs, cover the control spool
and springs with a clean shop towel when
pushing springs from the spool. This will help
contain springs in one location (step 21).
Plug
O ring
Relief Valve
Valve Housing
(for Relief Valve Option)
NOTE!
Valve housing with inlet relief valve has one
O ring on the plug. After O ring replacement,
install relief valve and plug into valve
housing and torque plug to 30-34 ft-lb (41-46
N$m).
To Next Page
Loading...
