PS S4.0 4130
001 OE35
Version no T-code
F-code Section C-code
Torque Generator
114
Service Manual 1997-10-27
14.Again using a small screwdriver or similar tool, remove
O ring from the valve housing.
15.Remove the control end drive from the spool/sleeve
assembly in the valve housing.
16.Re-position valve housing, shaft horizontal and
remove the spool/sleeve assembly.
17.Re-position valve housing shaft end up. Use a small
screwdriver or similar tool to remove shaft seal.
18.Remove the washer from spool/sleeve assembly.
19.To separate spool from the sleeve, the cross pin must
be removed. To remove the cross pin, use a small
screwdriver or similar tool and push pin from the spool/
sleeve.
Valve Housing
Washer
Shaft Seal
(can be
Quad Seal
or Lip Seal)
Sleeve Spool
Centering Springs
Retaining Ring
and Cross Pin
6 Springs
(Standard)
Sleeve
Spool and Retaining Ring
6 Springs and 4 Spacers
for Increased Input Torque
Spool (Special for Increased Input Torque)
Pin
To Next Page
Loading...
