Torque Generator
PS S4.0 4130
F-code Section C-code
Version no T-code
001 OE35
© BT Products
113
Service Manual 1997-10-27
6. Use a small screwdriver or similar tool to remove O
ring from the spacer plate.
7. Remove spacer plate from the gerotor or Geroler.
8. Remove drive (power end) from the gerotor or Geroler.
9. Remove O ring from the gerotor or Geroler.
10.Remove the gerotor or Geroler.
11.Remove the spacer.
12.Using a small screwdriver or similar tool, remove the O
ring from the spacer plate.
13.Remove spacer plate from the valve housing.
Drive
(power end)
O ring
Gerotor or Geroler
Spacer Plate
O ring
Drive
Spacer
Plate
Spacer
Geroler
NOTE!
Remove the gerotor or Geroler, try to keep
all parts together, Geroler has 7 rolls to
retain along with the star (step 10).
To Next Page
Loading...
