PS S4.0 4130
001 OE35
Version no T-code
F-code Section C-code
Torque Generator
112
Service Manual 1997-10-27
3. Remove the housing (power end) and shaft assembly.
4. Turn the housing and shaft assembly over and remove
the shaft with retaining ring in place.
5. Remove both washers from the housing (power end),
and re-position the housing with seal end up. Use
small screwdriver or similar tool to remove quad seal
from the housing. Housing with two bearing sets
(needle type) use the same output shaft, quad seal,
washers, and retaining ring as the standard housing,
however if bearings are to be replaced they are not
sold separately as replacement parts.
Housing and Shaft Assembly
Key
Cap Screw
NOTE!
In most cases it is not necessary to remove
the retaining ring from the shaft.
Housing (bearings -- Needle type)
Shaft and Retaining Ring
(power end)
Housing (Standard)
Quad Seal
Washer
Washer
To Next Page
Loading...
