PS S4.0 4130
001 OE35
Version no T-code
F-code Section C-code
Torque Generator
120
Service Manual 1997-10-27
19.Lubricate and install the O ring into the gerotor or
Geroler.
20.Install the spacer in the Geroler star.
21.Lubricate and install the drive into the gerotor or
Geroler star.
22.Lubricate and install the spacer plate, with the seal
groove side facing upward. Install by aligning the cap
screw holes with the matching holes in the gerotor or
Geroler.
23.Lubricate and install the O ring in the groove located in
the spacer plate.
Drive
(power end)
O ring
Gerotor or Geroler
Spacer Plate
NOTE!
The spline on one end of the drive is not as
thick as the other and this thinner spline end
must be installed into the gerotor or Geroler
star.
Housing (bearings -- Needle type)
Shaft and Retaining Ring
(power end)
Housing (Standard)
Quad Seal
Washer
Washer
To Next Page
Loading...
