Steering System Pump
PS S4.0 4150
F-code Section C-code
Version no T-code
001 OE35
© BT Products
129
Service Manual 1997-10-29
6. Place gasket between mating surfaces and install
end body to intermediate body.
7. Tighten eight bolts holding pump together to 10 ft-
lb +/- 0.5 ft-lb.
8. Install relief valve balls, springs, and screws.
Do
not
tighten down caps until relief pressures have
been checked and adjusted.
9. Install shaft seal in front housing. Outer face of seal
should be recessed 0.5 in. from front edge of bore.
10.Install coupling half on front of input shaft.
11.Install solenoid valve and coil in end body.
To Next Page
Loading...
