Electrical System with TX and TT Card
PS S5.0 5000
F-code Section C-code
Version no T-code
001 OE35
© BT Products
147
Service Manual 1997-10-23
If capacitor 1C terminals are not accessible, discharge
capacitor by connecting from SCR POS terminal to 2 REC
anode. Check resistance on Rx1000 scale from frame to SCR
power and control terminals. A resistance of less than 20,000
ohms can cause misleading symptoms. Resistance less than
1000 ohms should be corrected first.
Before proceeding, visually check for loose wiring, misaligned
linkage to the accelerator switch, signs of overheating of
components, etc.
Tools and test equipment required are: (a) 6-volt lamp, 6-volt
battery, two A14 diodes (1 Amp 400 volts), clip leads, volt-
ohm meter (20,000 ohms per volt) and general hand tools.
Before trouble-shooting, jack up wheels,
disconnect the battery, and discharge
capacitor 1C. Reconnect the battery as
needed for the specific check.
WARNING
To Next Page
Loading...
