PS S5.3 5230
001
Version no T-code
F-code Section C-code
SCR Component Checks
186
Service Manual 1997-04-15
To insert a terminal into the plug body.
Referring to Figure 2, orient the plug body as shown
with the latch up, and terminal locking lance up.
Check that the locking lance protrudes .030 to .060
inches (.8 to 1.5mm). If not, adjust the lance. Insert the
terminal into the plug body until it latches. A "CLICK"
sound will be heard when the terminal latches. Check
for correct latching by moving the wire gently - with a
push-pull motion.
12.3. Reference
“A” Plug 27694-00
“B” Plug 27702-02
Receptacle AMP #102103-3 (Loose) AMP
#102099-5 (Reel, side-feed)
Crimp Tool AMP #90274-2 (wire size, 18-22)
Removal Tool AMP 91065-1
Terminal Lube AMP #561232-1
Figure 2
Orient Plug
Check lance height
Insert Until
Check sound is heard
Check with Gentle
Push-pull motion
on the wire
To Next Page
Loading...
