PS S5.4 5460
001 OE35
Version no T-code
F-code Section C-code
Electrical System Troubleshooting Charts
204
Service Manual 1996-10-15
start switch.
6. Negative side of start switch (push button
engaged).
0 volts, replace start switch.
7. Positive side of emergency disconnect
contactor coil.
0 volts, repair open wiring from push button to
contactor coil.
8. Negative side of emergency disconnect
contactor coil.
0 volts, replace contactor coil, check for
mechanical binding of contactor.
Battery volts, repair open wiring from contactor
coil to battery negative, wire #22.
1.1.2 Emergency disconnect contactor closes, but drops
out when start switch is released.
Condition for test: Battery plugged in, key switch
ON position.
Test for battery volts at:
1. Negative side of key switch, wire #14.
0 volts, replace key switch.
2. Positive side of emergency disconnect push
button.
0 volts, repair open wiring from key switch to
emergency disconnect push button.
3. Negative side of emergency disconnect push
button.
0 volts, replace push button.
4. Positive side of emergency disconnect
To Next Page
Loading...
