Lift Pump Assembly
PS M6.1 6140
F-code Section C-code
Version no T-code
001 OE35
© BT Products
257
Service Manual 1997-12-15
drive gear bushing. Install drive gear (7) and driven
gear (14), with long journal toward the shaft seal of
the pump.
6. Lubricate rear gear faces and journals with SAE 10
oil and install trust plate (6) in its original position,
bronze face toward the gears.
7. Apply a small amount of grease to rear cover seal
(9) and install seal into groove.
8. Lubricate rear cover bushings with SAE 10 oil.
9. Position pump with shaft end down, install the rear
cover (3), aline scribe marks on cover and body.
10.Insert cap screws (12) and washers in pump body.
Torque screws to 34 to 38 ft-lb.
11.Check that drive shaft turns with adjustable wrench
without evidence of mechanical bind.
To Next Page
Loading...
