PS S7.1 7110
001 OE35
Version no T-code
F-code Section C-code
Mast, 3 Stage
280
Service Manual 1996-10-15
18.Install lift chain anchors through outer column and
thread wheel nut on anchors and secure with jam
nut.
19.Install lift chain on chain anchors and secure with
chain pins. After chain pins have been installed,
run lift chain over chain sheaves, making sure
chain and sheaves are properly aligned.
20.Install freelift cylinder assembly on inner column
and secure with four cap screws and nuts.
21.Connect hydraulic lines to lift cylinder.
22.Lubricate the grease fittings with Tex. Ref. C & C
No. 880 using a standard lube gun.
To Next Page
Loading...
