Freelift Cylinder, 3 Stage
PS S7.3 7310
F-code Section C-code
Version no T-code
000 OE35
© BT Products
287
Service Manual 1997-12-15
1.2. Disassembly
1. Remove gland nut (10) from the cylinder tube (14).
2. Remove and discard packing, back-up ring, O ring,
rod wiper and bearing retainer from the gland nut
(10). Use care
NOT
to damage the inside of the
gland nut (10).
1.3. Assembly
1. Install new bearing, seals and rod wiper in the
gland. The “lip” of the wiper must face outward. It is
not necessary to replace wear ring (6), unless the
rod was removed for repair.
1.4. Installation
1. Install crosshead, chains, hoses and electric
cables.
2. Connect battery.
3. Test for proper operation.
To Next Page
Loading...
