PS S8.0 8200
001 OE35
Version no T-code
F-code Section C-code
Micro 70 Wire Guidance
304
Service Manual 1997-10-24
must be moved at least two truck lengths after the
"on wire" light has turned on before the travel
direction can be reversed.
6.3. Daily operational checks
Operational checks are performed for operator safety and to
prevent damage to the facility or truck. If any problems are
noticed during daily inspections notify your foreman or
supervisor to take corrective action. These checks are in
addition to any checks recommended in the vehicle
operator's manual.
1. Check for oil leaks, missing or damaged parts, or
other conditions that may prevent the truck from
operating satisfactorily.
2. Inspect cables, hoses, tires, and mechanical
components for physical damage.
3. Check antennas for physical damage.
4. Insure that all truck functions are working properly.
This should include brakes, lift controls, steering,
and travel controls. Check for any unusual noises or
other indications of potential trouble.
5. Make sure the truck battery is fully charged at the
beginning of each work shift. The N.D.C Micro 70
guidance system will not function properly with a
battery charge that is too low.
To Next Page
Loading...
