Transmission
PS S2.0 2550
F-code Section C-code
Version no T-code
000 OE35
© BT Products
87
Service Manual 1997-10-21
1. Park the truck on a level surface and make sure
load wheels are blocked to prevent accidental
movement.
2. Fully lower the mast.
3. Disconnect and remove battery from unit to
prevent accidental operation.
3. Label the motor power cables and remove cables
from drive motor.
4. Disconnect wire from the brake interlock switch.
5. Disconnect the wires from the steering travel
limiting switch.
6. Pull cables and wires up through the transmission
tube.
7. Disconnect the hydraulic return hose from the
control valve to the filter. Unbolt the control valve
bracket from the truck frame. Lay the control valve
off to the side.
8. Remove the brake cylinder from the transmission.
It is not necessary to disconnect the hydraulic
hose.
9. Raise and block the front of the truck for access
under truck.
10.Drain fluid from transmission.
11.Put transmission in straight ahead position and
mark the location of steering chain to transmission
for ease of reassembly.
12.Remove the steering chain from around
transmission and sprocket.
13.Loosen the cam adjustments on the steering guide
rollers.
14.Support the transmission from overhead. A chain
through the pivot tube is most convenient.
15.Remove the three cap screw that bolt the
transmission pivot mount to the truck frame.
16.The transmission can now be lifted up and away
from the truck.
To Next Page
Loading...
