BT OE35 - Page 95

Transmission Disassembly / Assembly
PS S2.0 2550
F-code Section C-code
Version no T-code
000 OE35
© BT Products
93
Service Manual 1997-10-21
22.Install second bearing cone over drive axle.
23.Install lip seal in transmission case.
24.Install wheel hub on drive axle.
25.Put a solid bead of Loctite 515 "gasket eliminator"
around the seam between the axle and the hub.
26.Use Loctite thread lock on axle locknut and install
axle locknut on axle. Torque locknut to 250 ft-lb
while rotating the axle.
27.Press the intermediate gear bearing into the gear
case. Install the bearing cone and one 0.010 in.
shim. Use Loctite 515 as sealant and use Loctite
threadlock on the cover screws.
Do not
install the
intermediate gear at this time.
28.Install the motor adapter and motor pinion gears on
the drive motor armature shaft. If new adapter and
pinion gears are used they should be “snapped”
together by striking with a lead hammer.
29.Install a new gasket on the drive motor. Use a
small amount of Loctite 515 as sealant.
Drive Motor
Gasket
Motor
Adapter
Motor
Pinion
Return