PS S2.0 2550
000 OE35
Version noT-code
F-code Section C-code
Transmission Disassembly / Assembly
92
Service Manual 1997-10-21
11.Remove bearing races from case.
12.Remove motor pinion bearing and cover and
intermediate gear bearing and cover from side
cover.
13.Remove intermediate gear bearing and cover from
case.
14.Remove all old gasket material from cover, case
and drive motor.
15.Clean all parts in safety solvent and dry with
compressed air.
16.Inspect all gears for damage and wear.
17.Discard all o-rings and bearings. New parts should
be used during reassembly.
18.Install the drive axle bearing races into the gear
case. Races should be installed with the smallest
inside diameters back-to-back and tight against the
snap rings.
19.Press one bearing cone on the drive axle with the
large diameter against the gear.
20.Place the drive axle into the case.
21 Turn the gear case over with the gear side down.
Support the drive gear from underneath.
Locknut
Wheel
Hub
Seal
Bearing
Bearing
Case
Drive Gear
To Next Page
Loading...
