Buchi FatExtractor E-500 - Preparing the instrument for Soxhlet Extraction; Installations for Soxhlet Extraction; Preparing the extraction glass chamber Soxhlet

BÜCHI Labortechnik AG Installation | 5
Operation Manual FatExtractor E-500 31/88
u Put the tank bottle in the instrument.
5.9 Preparing the instrument for Soxhlet Extraction
5.9.1 Installations for Soxhlet Extraction
u Prepare the condenser. See Chapter5.13 "Preparing the condenser",
page36
u Prepare the extraction glass chamber Soxhlet. See Chapter5.9.3 "In-
stalling the extraction glass chamber Soxhlet", page32
u Install the protection shields. See Chapter5.12.1 "Installing two protec-
tion shields (Soxhlet only)", page35
u Select the Soxhlet method on the interface. See Chapter5.14 "Selecting
a configuration", page39
5.9.2 Preparing the extraction glass chamber Soxhlet
NOTICE
Risk of broken parts by using tools
Using tools for preparing the instrument can break parts.
u Tighten all parts with your hands.
u Attach the valve to the extraction glass cham-
ber at the point indicated.
NOTICE!Make sure that the sensor is not bent
during carrying out this action step
u Attach the sensor to the extraction glass
chamber.