Buchi FatExtractor E-500 - Selecting a configuration

BÜCHI Labortechnik AG Installation | 5
Operation Manual FatExtractor E-500 39/88
u Make sure that the condenser circuit is com-
plete. See Chapter14.1 "Schematics",
page81
5.14 Selecting a configuration
Navigation path
➔ ➔ [Settings]
Precondition:
R Switch the On/Off master switch to On.
u Navigate to the [Settings] submenu via the navigation path.
u Tap the action [Select configuration].
ð The display shows a dialog with the selectable configurations.
u Tap the configuration according to the installed glass setup.
ð The configuration is selected.
ð The dialog box closes.
5.15 Disassembling the condenser circuit
u Disconnect the indicated condenser connec-
tion.
u Make sure, that there is no coolant in the con-
denser circuit.
u Disconnect the other condenser connections.
u Remove the flange lock.