Entering system settings (Service menu – Settings)
6
RC35 programming unit - Technical specifications are subject to change without prior notice.
29
By how many degrees
Kelvin should the flow
temp. be reduced each
time?
5K
0 to 20K
Can only be set if direct normal
operation has not been entered
for flow temperature reduction.
1)
Do you wish to change the
switching program?
Yes, No Selecting Yes takes you to the
switching program for the heating
circuit.
Should the switching pro-
gram be optimised?
Yes, No Switch-on and switch-off times are
automatically adjusted according to
the outside temperature, room tem-
perature and building type (heat
storage capacity).
What reduction mode
should be used for holiday?
Outdoor setback mode,
reduced operation, room
setback mode, shut-down
mode
See page 32.
Room setback mode can only be
set if a remote control unit (e.g.
RC20) has been assigned to the
heating circuit.
If reduced operation is selected,
the normal night temperature will
be used.
What outside temp. should
be used?
5°C
-20°C to +10°C
Temperature threshold for outdoor
setback mode (see page 32).
Setting entered only if the reduc-
tion mode for holiday has been set
to outdoor setback mode.
1) Not possible or not available for boilers with UBA1.x and DBA.
Menu item
Input range
Factory setting in bold Other information
Table 11 Navigator for Service menu SETTINGS \ HTG. CIRC. 1
To Next Page
Loading...
Need help?
General
