Burk ARC Plus Touch - RSI Phrases Configuration; Setting RSI Greeting Messages

67
When the RSI dials out with alarm notifications, the phone line will not allow inbound calls. Adding a delay
between dial-out attempts allows users the opportunity to dial in. Configure the duration of this delay in the
Wait ___ seconds before dialing… field.
Finally, enter System and Operator PINs that will be used for RSI login purposes. The system PIN provides full
access to the ARC Plus Touch system (including editing master phone numbers, disabling alarm reporting, and
muting channels), while the operator PIN allows readings, commands and macros. PINs may contain up to eight
digits.
RSI PHRASES
The ESI Phrases tab allows configuration of the phrases used to greet the caller, say goodbye, and accept or reject
passwords.
Edit>Settings>ESI Settings – Phrases
Greeting
Spoken as soon as the RSI Plus picks up the line.
The word “Hello” is always spoken prior to the
greeting.
Welcome Message
Spoken after the user enters a valid PIN.
Rejection Message
Spoken if an incorrect PIN is entered.
Goodbye Message
Spoken when the caller disconnects. The word
“Goodbye” is always spoken after the message.