Burk ARC Plus Touch - Web Interface Navigation; Logging In and Out Procedures; Navigating Channels and Macros; Alarm Details Display on Web

24
LOGGING IN AND OUT
To log in, enter the IP address or domain name of the ARC Plus in your web browser. When the login screen
appears, enter your user name and password and click the login button. User names, passwords and privileges are
set up in AutoLoad Plus software. If none have been established, the default user name is admin and the default
password is password.
Use the Log Off link to end your session.
NAVIGATING THE WEB PAGE
CHANNELS
When you first log on, the web interface will display the Channels page. This
page displays your meter, status and command channels. Only unhidden
channels with a source assignment and name will appear in the lists.
Use the Channel Group drop down to select a predefined channel bank,
configured in AutoLoad Plus (Click or turn to CHANNEL BANKS), or to
display all the channels on your site.
MACROS
The Macros page displays a list of the macros on your ARC Plus, along with their status. Use the Run and
Stop buttons to run/stop a macro.
ALARMS
The Alarm page displays the alarms on this ARC Plus, with the following fields:
Use the Clear link to clear an alarm, or Clear all alarms to clear all. Use the
Show more or Show all links at the bottom of the page to display more alarms.
When all alarms are displayed, “All alarms shown” will appear at the bottom of the
page.
Date/Time
The date/time when the alarm occurred
Duration
The duration of the alarm, if it has been resolved
Severity
The severity (warning or critical) of the alarm
Priority
The user-defined priority (a numeric value between 0 and 255)
Type
The type of alarm (such as status alarm or system alarm)
Message
A message describing the alarm description
Time Cleared
The time the alarm was cleared, or blank if not cleared
Raise and Lower commands will
present a confirmation prompt
before sending a command. To
disable this feature, navigate to
the System page and uncheck
Prompt for confirmation when
issuing a command.
The Alarms link in the
page header will display
a number next to the
link to indicate how
many uncleared alarms
are on the system.