Cleaning, maintenance and servicing
Translation of original operating manual
7 Cleaning, maintenance and servicing
When performing cleaning, maintenance and servicing, note as well the instructions in
Chapter:
“Obligations of the operator” on page 12,
“Personal qualifications” on page 13,
"General safety instructions" from page 17,
"Warning alerts and instructional notices" from page 21.
Your safety requires careful observance of this chapter.
Hazards to personnel due to pinching, shearing, cutting, severing, snagging, wind-
ing, pulling, catching and impact can occur if the machine is accidentally started up.
Secure the machine against accidental startup (secure the main switch with a pad-
lock) prior to performing work on the machine.
Wait until the machine has stopped prior to entering the machine’s hazard area
Hazards to personnel due to pinching, shearing, cutting, severing, grasping, wind-
ing, pulling and catching can occur if danger spots are not protected!
Remount any protective equipment that has been removed for the cleaning, mainte-
nance and servicing of the machine.
Replace defective protective equipment with new protective equipment.
Hazardous situations can occur if mechanical work on frame sections damages
load-bearing parts!
It is strictly prohibited to:
bore holes in the frame.
re-bore existing holes in the frame.
Weld load-bearing parts.
To Next Page
