An oil change requires approximately 1.6 liters of
SAE 80/85 oil (API GL5, VG 150). Perform oil changes
only at the oil’s operating temperature. The operating
temperature is approximately 30°C-40°C.
1. Switch the motor off and ensure that it cannot be
unintentionally switched on again.
2. Place a collecting container under the gearbox (ap-
prox. capacity: 5 liters).
3. Unscrew and remove the lower oil drain screw (2)
(not shown) on the gearbox.
4. Wait until no further oil emerges from the oil drain
plug.
5. Screw in and tighten the oil drain screw (2) (use ap-
propriate sealant).
6. Unscrew and remove the ventilation screw (1) on
the gearbox.
7. Add 1.6 liters transmission oil via the ventilation
screw (1).
8. Screw in and tighten the oil drain screw (1) (use ap-
propriate sealant).
To Next Page
Loading...
