YAK 130
BVM ©2016 12 Mar. 23, 2016
Use a pointed awl to align the holes in the inlet
plywood bracket to those in the fuse former.
With the awl in one hole set, install (2) 2.5mm x
14mm SHCS per duct side. Remove the awl
and install the remaining SHCS.
A Neat Trick
Use a scrap of note pad paper on the bolt head
and push the Hex wrench into the socket.
This will help hold the bolt onto the wrench to get it
into the tight 3 and 9 o’clock Aluminum pins.
To Next Page
Loading...
