EasyManua.ls Logo

Cadel nice - Failed Ignition; Power Failure; Temperature Setting; Fume Temperature

Cadel nice
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
68
NICE - MIRIAM - CRISTAL - LEONORA - PRETTY - DIANA - KRISS - MARY
EN
Fig. 22 - Air regulator
Air regulator entrance 12 mm to nominal power with a chimney ue of 11 Pa.
10.8 FAILED IGNITION
If the pellets do not burn, the failed ignition will be indicated by the alarm “FAILED IGNITION”.
If the room temperature is lower than 10°C, the plug is not able to bear the ignition stage. To support
it please insert some pellets in the burning pot and a piece of burning relighter igniter material on the
pellets (for example relighters cubes).
After a failed ignition the burning pot must be empty from the amassed pellets, before
starting the stove up again.
Too much pellets in the burning pot, or humid pellet, or sooty burning pot make ignition difcult and
create dense white smoke which is harmful to health and can cause explosions on the combustion
chamber. It is therefore necessary not to stand in front of the stove during ignition stage if dense white
smoke is present.
If after some months the ame appears weak and/or orange colored or the glass tends
to blackens and the burning pot to become encrusted, clean the stove, clean the
fume conduit and the chimney ue.
10.9 POWER FAILURE
After a black-out lower than 5 seconds, the stove turns back to the power which was settled.
After a black-out of more than 5 seconds, the stove enters the “COOLING WAIT” phase. Completed this
phase, it starts automatically up with the different phases (see START UP page 67).
10.10 TEMPERATURE SETTING
To modify the ambient temperature it is sufcient to press P1 and P2 keys according to the desired
temperature inside the menu “SET TEMP AMBIENT”.
To see the set temperature, press once P1 key.
10.11 FUME TEMPERATURE
To check the fume temperature at the exhaust it is sufcient to keep pressed P2 key.
10.12 SWITCHING OFF
To switch the stove off, keep pressed P4 key: the display shows “FINAL CLEANING”. After about 10 minutes,
also the fume fan switches off (this happens always, independently if the stove is hot or cold). Then “OFF”

Table of Contents

Other manuals for Cadel nice

Related product manuals