Cadel nice - Hopper and Auger Cleaning

74
NICE - MIRIAM - CRISTAL - LEONORA - PRETTY - DIANA - KRISS - MARY
EN
Fig. 28 - Burning pot box cleaning Fig. 29 - Cleaning with a brush Fig. 30 - Correct position of the re plate
• Clean and drain away the burning pot from ash which has accumulated in its inner (see Fig. 28 page
74).
• Clean also the hole for pellet drop with a brush (see Fig. 29 page 74).
• Check if the re plate is placed in the correct position (see Fig. 30 page 74).
• The ash remains have to be stored in a metal container with a sealed lid and this container must never
get in touch with combustible materials (for example put on a wooden oor), as the inner ash keeps the
embers ring for a long time.
• Only when the embers are off the ash coul be poured in the organic waste.
• Pay attention if the ame becomes red colured, if it is weak or if black smoke creates in the inner: in this
case the burning pot is encrusted and needs to be cleaned. If it is broken, it must be replaced.
•
12.3 HOPPER AND AUGER CLEANING
Per each pellets supply, check the probable presence of meal, sawdust and other remanins on the hopper
bottom. If present, they must be removed with the aid of a vacuum cleaner (see Fig. 31 page 74).
Fig. 31 - Hopper and auger cleaning
The hand rejector grid must not ever be removed fron its housing. Clean the hopper
bottom and the visible part of the auger exclusively as shown in the picture (see Fig. 31
page 74).