Turn SignaVMultifunction
Lever
Tbrn and Lane Change Signals
To
signal a turn, move the lever
all
the way up
or
down.
The lever returns automatically when the
turn
is
complete.
I
A
I
An arrow on the instrument
panel will flash in the
direction of the turn or
lane change.
Raise or lower the lever until the arrow starts
to
flash to
signal a lane change. Hold it there until the lane change
is complete. The lever returns when it’s released.
If the turn signal
is
left on, a warning chime will sound
and the Driver Information Center (DIC) will display
TURN
SIGNAL
ON
(after driving about a mile)
to
remind you to turn
it
off.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned out signal bulb.
Other drivers won’t see the turn signal.
Replace burned-out bulbs to help avoid possible
accidents. Check the fuse (see “Fuses and Circuit
Breakers” in the Index) and for burned-out bulbs if the
arrow fails
to
work when signaling a turn.
Headlamp
High/Low
Beam Changer
Pull the turn signal lever all
the way toward you and
then release it to change the
headlamps from low beam
to high or from high beam
to low.
This light on the instr..__lent panel will
be
on,
indicating
high beam usage.
To Next Page
Loading...
Need help?
General
