Flash-To-Pass
Windshield Wipers
This lets you use the high-beam headlamps to signal the
driver in front
of
you that you want to pass.
Pull the turn signal lever toward you to use. When
you do:
If
the headlamps are either
off
or in the
DRL
mode,
the high-beam headlamps will turn on. They'll stay
on as long as you hold the lever there. Release the
lever to turn them
off.
If
the headlamps are on low beam, they will shift to
high beam and stay there. Pull the lever toward you
to return to low beam.
a
If
the headlamps
are
on
high beam, they will switch
to low beam. To return to high beam, pull the lever
toward you.
WIPER:
Turn the band on the turn signal lever to
control
the
wipers.
MIST:
Turn the band toward you and then release it for
a single wiping cycle. For more cycles, hold the band
on
-
MIST longer.
LO
or
HI:
Turn the band away from you to either
LO
(low speed) or to
HI
(high speed), depending on the
wiper speed you want.