Finding
a
Station
BAND:
Press this button to select
AM,
FM1
or
F"2
and preset stations.
SEEK-TUNE:
Press and release
this
button to seek to
the next higher or lower radio station. Pressing and
holding this button until a chime sounds puts the radio
in a tune mode. In this mode, higher or lower radio
stations are advanced to in small increments until the
SEEK-TUNE
button is released. Tuning stops when
you release this button. If you press and hold the
SEEK-TUNE button again within five seconds of
being in the tune mode, tuning will continue. Waiting
longer than five seconds places the radio back in the
seek mode.
2.
Press BAND
to
select
AM,
FM1
or
FM2.
SCAN:
Press this button and SCAN will appear on the
display. Use SCAN to listen to stations for a few
seconds. The radio will go to a station, stop for a few
seconds, then go on to the next station. Press this button
again to stop scanning.
PUSHBUTTONS:
The six numbered pushbuttons let
you return to your favorite stations. You can set up to
18
stations (six
AM,
six
FM1
and six
FM2).
Just:
1.
Turn the radio on.
3.
Tune in the desired station.
4.
Press and hold one of the six numbered buttons for
more than two seconds until you hear a beep.
Whenever you press that numbered button for less
than two seconds, the station you set will return.
5.
Repeat the steps for each pushbutton.
When battery power is removed and later applied, you
will not have to reset your radio presets because the
radio remembers them.
PRESET SCAN:
Press and hold SCAN for two to
three seconds until PRESET SCAN appears on the
display to listen to each of your preset stations for a
few seconds (factory presets which have not been
reprogrammed with your stations will be ignored).
The radio will go to the first preset station stored on
your
pushbuttons, stop for a few seconds, then
go
on
to the next preset station. Press SCAN again to stop
scanning.
If
a preset station has weak reception, the
radio will not stop at the preset station.
To Next Page
Loading...
Need help?
General
