Setting Cruise Control
If
you leave your cruise control switch on when
you’re not using cruise, you might hit a button
and
go
into cruise when you don’t want to. You
could be startled and even lose control. Keep the
cruise control switch
off
until you want to use it.
1.
Move the cruise control switch to
ON.
2.
Accelerate
to
the speed you want.
3.
Press the SET CRUISE button at the end of the lever
and release it. The CRUISE ENGAGED message
will display on the Driver Information Center (DIC).
4.
Remove your foot from the accelerator pedal.
Resuming a Set Speed
Setting the cruise control at
a
desired speed and then
applying the brake will end the cruise function.
Once you’re going about
25
mph
(40
km/h)
or more,
you can move the cruise control switch
from
ON
to
R/A
(Resume/Accelerate) for about half a second to
reset.
This
returns you
to
your desired preset speed. Also
note that the Driver Information Center (DIC) will
display the CRUISE ENGAGED message again.
Remember, if you hold the switch at R/A longer than
half a second, the vehicle will accelerate until
you
release the switch or apply the brake.
So
unless
you
want to
go
faster, don’t hold the switch at
R/A.
Increasing Speed While
Using
Cruise
Control
There are two ways to go to a higher speed:
Use the accelerator pedal to get to the higher speed.
Push the button at the end of the lever and then
release the button and the accelerator pedal. You’ll
now cruise at the higher speed.
0
Move the cruise switch
fiom
ON
to
FUA.
Hold it there
until you reach a desired
speed
and then release the
switch.
(To
increase your
speed
in very
small
amounts,
move the switch to
R/A.
Each time you do
this,
your
vehicle
will
go about
1
mph
(1.6
km/h)
faster.)
The accelerate feature will only work after you have
set the cruise control speed by pushing the SET
CRUISE button.
2-40
To Next Page
Loading...
Need help?
General
