Then, without shutting
off
the engine, follow these steps:
I
1.
The black transaxle fluid cap is located next to the
radiator hose and below the air cleaner assembly on
the driver’s side of the engine. Remove the air
cleaner assembly
so
you can reach the transaxle fluid
cap. The assembly
is
attached to the vehicle by two
fasteners. Lift up on the air cleaner assembly to
remove it.
2.
Find the transaxle fluid cap and turn it to the left
to remove.
3.
Pull out the dipstick and wipe it with a clean rag or
4.
Push it back in all the way, wait three seconds and
paper towel.
then pull it back out again.
5.
Check both sides of the dipstick, and read the
lower level. The fluid level must be in the
cross-hatched area.
6.
If the fluid level is in the acceptable range, push
the dipstick back in all the way. Replace the
air
cleaner assembly.
How
to
Add
Fluid
Refer to the Maintenance Schedule to determine
what kind of transaxle fluid to use. See “Recommended
Fluids and Lubricants” in the Maintenance
Schedule booklet.
6-20
To Next Page
Loading...
Need help?
General
