3.
4.
5.
Hold the end
of
the hand-held transmitter against the
front surface of the universal transmitter
so
that you
can still see the amber light.
Using both hands, press the hand-held transmitter
button and the desired button on the universal
transmitter. Continue to. press both buttons through
Step
5.
Hold down both buttons until you see the amber light
on the universal transmitter flash slowly and then
rapidly. The rapid flashing, which could take up to
90
seconds, indicates that the universal transmitter
has been programmed. Release both buttons once the
light starts to flash rapidly.
If
you have trouble programming the universal
transmitter, make sure that you have followed the
directions exactly as described and that the battery in the
hand-held transmitter is not dead.
If
you still cannot
program it, rotate the hand-held transmitter end over end
and
try
again. The universal transmitter may not work
with older garage door openers that do not meet current
Federal Consumer Safety Standards. If you cannot
program the transmitter after repeated attempts, consult
your dealer.
Be sure to keep the original hand-held transmitter
in
case
you need to erase and reprogram the universal transmitter.
on
Note
to
Canadian Owners:
During programming, the
hand-held transmitter may stop transmitting after one or
two seconds. If
you
are programming from one
of
these
transmitters, you should press and re-press the button
the hand-held transmitter every two seconds without
ever releasing the button on the universal transmitter.
Release both buttons
when
the amber light on the
universal transmitter begins to flash rapidly.
Operating the Transmitter
Press and hold the appropriate button on the universal
transmitter. The amber light comes on while the signal is
being transmitted.
Note that the universal transmitter is disabled when the
valet button inside the glove
box
is
activated. For more
information, see “Valet Lockout Button” earlier
in
this section.
Also note that if the hand-held transmitter appears to
program the universal transmitter but does not open
your garage door, and if the garage door opener was
manufactured after
1995,
the garage door opener may
have a “rolling code” system.
A
rolling code system
changes the code
of
the garage door opener every time
you open
or
close the garage door.
To determine if you have this system, press the button
on the universal transmitter that you have programmed
2-60
To Next Page
Loading...
Need help?
General
