Testing the Alarm
1.
From inside the vehicle, roll down the window, then
get out of the vehicle, keeping the door open.
2.
From outside
of
the vehicle, with the door open, lock
the vehicle using the power door lock or the remote
keyless entry transmitter and close the door. Wait
30
seconds until the SECURITY light goes
off.
3.
Reach in and unlock the door using the manual lock
and open the door. The horn
will
sound and the
headlamps will flash.
If
the alarm does not sound when it should, check to see
if the horn works. The horn fuse may be blown. To
replace the fuse, see “Fuses and Circuit Breakers” in the
Index.
If
the fuse does not need to be replaced, you may
need to have your vehicle serviced.
To reduce the possibility of theft, always activate the
theft-deterrent system when leaving your vehicle.
Valet
Lockout
Button
Pressing the valet button
located inside the glove box
will disable the use of the
power trunk, fuel door and
garage door openers.
Pressing this button again
will make these features
reusable. Locking the
glove box with the door
key will also help to secure
your vehicle.
Note that the remote keyless entry transmitter can’t be
used to open the
trunk
or
fuel
door if the valet button
is on.
2-16
To Next Page
Loading...
Need help?
General
