Universal Transmitter (Option)
This device complies with
Part
15
of the FCC Rules.
Operation is subject to the following two conditions:
(1)
this
device may not cause harmful interference,
and
(2)
this device must accept any interference
received, including interference that may cause
undesired operation.
This device complies with
RSS-210
of
Industry Canada.
Operation is subject to the following two conditions:
(1)
this
device may not cause interference, and
(2)
this
device must accept any interference, including
interference that may cause undesired operation of
the device.
Changes and modifications to this system
by
other than
an authorized service facility could void authorization to
use this equipment.
Programming the Transmitter
Do not use the universal transmitter with any garage
door opener that does not have the “stop and reverse”
safety feature. This includes any garage door opener
model manufactured before April
1,
1982.
Be sure that people and objects are clear of the garage
door you are programming.
Your vehicle’s engine should
be
turned off while
programming the transmitter. Follow these steps
to
program up to three channels:
1.
If you have previously programmed a transmitter
channel, proceed to Step
2.
Otherwise, hold down
the two outside buttons on the universal transmitter
until the amber light begins to flash rapidly
(approximately
20
seconds). Then release the
buttons. This procedure initializes the memory and
erases any previous settings for all three channels.
2.
Decide which one
of
the three channels you want
to program.
To Next Page
Loading...
Need help?
General
