Manual Operation
0
RECIRCULATION:
Press this button to
limit
the
amount of fresh
air
entering your vehicle. This is helpful
when you
are
trying to cool the air quickly or limit
odors entering your vehicle. In the AUTO mode, the
system will use recirculation as necessary to cool the
air.
Pressing the recirculation button will change the
operation to a manual mode and the
air
will recirculate
non-stop. Press this button again to turn off the
recirculation feature.
If you notice the windows fogging, press the
recirculation button to exit the recirculation mode.
OFF:
Press this button to turn the system
off.
Fresh
air will continue to flow through the vehicle, and
the system will try to maintain the previously set
temperature. The outside temperature will show in
the display when the system
is
off.
DEFOG:
Press this button to divide the air between the
windshield and the heater outlets. This is useful when
fog appears on the windshield or side glass due to
sudden rain or snowy conditions.
AUTOECON:
Press
this
button to switch between
AUTO and
ECON.
The
ECON
setting attempts to keep
air
at a selected temperature, however, it does not remove
humidity from the
air.
Use this setting in cold or cool
weather to save fuel. The AUTO setting is used when
it’s warm outside and you need
to
cool the
air
in order to
maintain
a
selected temperature and blower speed.
FAN
SPEEDS:
Press the button with the
fan
symbol
on it until AUTO is displayed on the screen. At this
setting, the fan speed is automatically controlled. If
it
is
cold outside, the blower may not run in the maximum
high fan speed right away. The system checks the
temperature of the engine coolant to assure it is warm
enough to provide heat. When the engine coolant is
warm, the controller allows the fan to gradually increase
.
to a higher speed. This prevents cold
air
from blowing
into the passenger compartment.
If
you want the blower
fan
at a high speed, press the up arrow button until you
see
HI
on the display. If you want the
fan
speed to be
automatic, but you like the
fan
speed to
be
higher than
the AUTO setting, press the fan symbol button until
HI
AUTO is shown on the display. If you want the blower
fan
at
a
low
speed,
press
the down arrow button until
LO
is
shown on the display.
If
you want the fan speed to run
lower than the AUTO setting, press the button until
AUTO
LO
is shown on the display.
DEFROST
Press this button to quickly remove
fog or frost from the windshield. This setting sends
most of the airflow to the windshield with only a
small amount to the floor outlets.
3-5
To Next Page
Loading...
Need help?
General
